remoter troll motor replacement from napa

#REMOTER TROLL MOTOR REPLACEMENT FROM NAPA SERIAL NUMBER#
#REMOTER TROLL MOTOR REPLACEMENT FROM NAPA MANUAL#

If you find the cable slipping on the drum, add more tension. This will be enough tension for most motors.

Tighten the nuts on the eyehooks equally until the body of the spring has spread to 3 5/8″.

Using a screwdriver helps to make the pulling easier.

Pull the spring down and attach it to the eyehook.

Put the left end over the left pulley and attach the spring to it.

When you have completed the third wrap, put the right end over the pulley and pull it down and attach it to the eyehbolt.

Now hold both wraps against the mounting plate and make a third wrap.

By holding the left side, you will be able to make the second wrap above (toward the motor) the first wrap. Easy to use for a replacement or new application.

Hold the first wrap on the left side against the motor mount and begin the second wrap. Seachoice electrical connectors are part of a deep selection of electrical accessories that provide long life in harse conditions.

The cable should now be wrapped around the drum, with the ends coming out between the two motor mount spacers.

Feed the cable down around the drum and up the left side until it comes out.

From the right side, insert the cable inside of the motor mount spacer.

#REMOTER TROLL MOTOR REPLACEMENT FROM NAPA SERIAL NUMBER#

You are able to search by serial number or search by parts diagram. You can find parts diagrams and buy parts online directly at our online Parts Portal at anytime.

Stand with the bottom of the Remote-Troll toward you. Replacement Parts and Service Buy Replacement Parts Updated 16 days ago Buy Parts within the U.S.Position the Remote-Troll on a workbench with the wood (or the black High Density Polyethylene) facing up.Remove the Remote-Troll from the boat by removing the two bottom bolts and lifting the Remote-Troll from the mounting bracket.Therefore, use dry fitting to make sure you have the correct bracket before drilling any holes. If you drill holes in a Remote-Troll bracket, it cannot be returned for exchange for a different bracket. Make sure, also, that the Remote-Troll is not too low – compare the water line with the depth sticker on the Remote-Troll. Does this location place the Remote-Troll square with the boat? Is there any interference with cables, fuel lines, trim tabs, or the main motor? Will this location put the propeller of the trolling motor sufficiently deep in the water? The cavitation plate should be a minimum of 1”-2” below the water – more if you will be using the trolling motor in big water, such as the ocean or Great Lakes. With some assistance, hold the Remote-Troll in place. 2006 honda accord blower motor replacement, 25 cm wide side table. IMPORTANT: BEFORE DRILLING ANY HOLES IN THE BOAT, “DRY FIT” YOUR REMOTE-TROLL. Bombshell geraldo rivera, 80 lb trolling motor for sale, Elizabeth sun 2017 gogol.

If there is any question regarding the installation, please contact your dealer or Remote-Troll Mfg.

#REMOTER TROLL MOTOR REPLACEMENT FROM NAPA MANUAL#

Ensure your Remote Troll is properly installed per owners manual and a copy of owners manual is received. Ask dealer to explain installation and review instructions. Review the detailed instructions describing the proper installation of the Remote-Troll bracket.

Remoter troll motor replacement from napa